After some time of use the release valve can get contaminated by soap residue and other debris. It is therefore important to make sure you regularly remove and clean the valve in order to keep your pump in full working order.
The valve parts are designed to be disassembled by the user for cleaning or to replace a worn valve part. To disassemble the valve you need a small flat bladed screwdriver or similar tool
- Locate the maintenance slots, these are situated on either side of the valve cap
- Insert the flat blade of the screwdriver into one of the slots and gently ease the valve cap upwards approximately 1 mm by twisting the screwdriver, be sure to apply only moderate pressure, so as not to damage the valve plastic.
- As the valve lifts, switch slots and ease the valve cap from the other side by 1 mm this keeps the cap level and will prevent damage to the valve seat.
- Alternate sides, easing the valve cap up 1 mm at a time until the valve cap pops off the valve body.
- Remove the valve cap, grip the black pip and pull the valve inner out of the valve body.
- The valve is disassembled; you can now clean all the parts with warm soapy water and rinse with clean water.
- To reassemble the valve, grip the black pip and place the valve inner into the valve body, with the soft translucent valve seal downwards. Ensure the valve inner is seated correctly with the black pip perpendicular to the valve body.
- Note that the black pip and the valve cap opening are both rectangular, ensure that when replacing the valve cap you orientate the valve opening correctly so that the black pip passes clearly though the opening.
- Place the valve cap back onto the valve body, check the orientation, and then press the valve cap firmly downwards with the heel of your hand. Use firm steady pressure, the valve will move against the internal spring and then stop, and you should hear and feel the valve cap click back into position. Do not attempt to relocate the valve cap with a violent or striking motion as this may damage the valve seat or valve inner.
- With the valve cap seated fully, check that the black pip moves up and down freely.